Room-Temperature Quantum Hall Effect in Graphene

See allHide authors and affiliations

Science  09 Mar 2007:
Vol. 315, Issue 5817, pp. 1379
DOI: 10.1126/science.1137201


The quantum Hall effect (QHE), one example of a quantum phenomenon that occurs on a truly macroscopic scale, has attracted intense interest since its discovery in 1980 and has helped elucidate many important aspects of quantum physics. It has also led to the establishment of a new metrological standard, the resistance quantum. Disappointingly, however, the QHE has been observed only at liquid-helium temperatures. We show that in graphene, in a single atomic layer of carbon, the QHE can be measured reliably even at room temperature, which makes possible QHE resistance standards becoming available to a broader community, outside a few national institutions.

The quantum Hall effect (QHE), one example of a quantum phenomenon that occurs on a truly macroscopic scale, has been attracting intense interest since its discovery in 1980 (1). The QHE, exclusive to two-dimensional (2D) metals, has elucidated many important aspects of quantum physics and has deepened our understanding of interacting systems. It has also led to the establishment of a new metrological standard, the resistance quantum, h/e2, that contains only fundamental constants of the electron charge, e, and Planck's constant, h (2). As with many other quantum phenomena, the observation of the QHE usually requires low temperatures, typically below the boiling point of liquid helium (1). Efforts to extend the QHE temperature range by, for example, using semiconductors with small effective masses of charge carriers have so far failed to reach temperatures above 30 K (3, 4). These efforts are driven by both an innate desire to observe apparently fragile quantum phenomena under ambient conditions and the pragmatic need to perform metrology at room, or at least liquid-nitrogen, temperatures. More robust quantum states, implied by their persistence to higher temperatures, would also provide added freedom to investigate finer features of the QHE and, possibly, allow higher quantization accuracy (2). We show that in graphene, a single layer of carbon atoms tightly packed in a honeycomb crystal lattice, the QHE can be observed even at room temperature. This is due to the highly unusual nature of charge carriers in graphene, which behave as massless relativistic particles (Dirac fermions) and move with little scattering under ambient conditions (5, 6).

Figure 1A shows one of our devices used in the QHE measurements. At room temperature, its Hall conductivity, σxy, reveals plateaus at 2e2/h for both electrons and holes, while the longitudinal conductivity, ρxx, approaches zero (<10 ohms) exhibiting an activation energy ΔE ≈ 600 K (Fig. 1B). The quantization in σxy is exact within an experimental accuracy ≈ 0.2% (Fig. 1C). The survival of the QHE to such high temperatures can be attributed to the large cyclotron gaps, ħωc, characteristic to Dirac fermions in graphene. Their energy quantization in a magnetic field, B, is described by Math, where vF ≈ 106 ms–1 is the Fermi velocity and N an integer Landau level (LL) number (5, 6). The expression yields an energy gap ΔE ≈ 2800 K at B = 45 T if the Fermi energy, EF, lies between the lowest LL, N = 0, and the first excited one, N = ±1 (Fig. 1B, inset). This implies that, in our experiments at room temperature, ħωc exceeded the thermal energy, kBT, by a factor of 10. In addition to the large ħωc, there are a number of other factors that help the QHE in graphene to survive to such high temperatures. First, graphene devices allow for very high carrier concentrations (up to 1013 cm–2) with only a single 2D subband occupied, which is essential to fully populate the lowest LL even in ultra-high B. This is in contrast to traditional 2D systems (for example, GaAs heterostructures), which are either depopulated already in moderate B or exhibit multiple subband occupation, leading to the reduction of the effective energy gap to values well below ħωc. Second, the mobility, μ, of Dirac fermions in our samples does not change appreciably from liquid-helium to room temperature. It remains at ≈ 10,000 cm2 V–1 s–1, which yields a scattering time of τ ∼10–13 s so that the high field limit ωcτ = μ · B ≫ 1 is reached in fields of several T.

Fig. 1.

Room-temperature QHE in graphene. (A) Optical micrograph of one of the devices used in the measurements. The scale is given by the Hall bar's width of 2 μm. Device fabrication procedures were described in (5). (B) σxy (red) and ρxx (blue) as a function of gate voltages (Vg) in a magnetic field of 29 T. Positive values of Vg induce electrons, and negative values of Vg induce holes, in concentrations n = (7.2 × 1010 cm–2 V–1)Vg (5, 6). (Inset) The LL quantization for Dirac fermions. (C) Hall resistance, Rxy, for electrons (red) and holes (green) shows the accuracy of the observed quantization at 45 T.

These characteristics of graphene foster hopes for the room-temperature QHE observable in fields substantially smaller than 30 T. In fact, we observed the Hall plateaus developing already in B <20 T at 300 K. The need for high B is attributed to broadened LLs caused by disorder, which reduces the activation energy. We expect that improving sample homogeneity and achieving higher μ (currently limited by static defects) should allow the observation of the room-temperature QHE by using conventional magnets. This should open up new vistas for developing graphene-based resistance standards (certainly, operational above liquid-nitrogen temperature) and for novel quantum devices working at elevated temperatures.


Stay Connected to Science

Navigate This Article